Turbo Cell Cleaner | TC-G002

#TC-G002 Hayward Turbo Cell Cleaner Adapter

Model # T-CELL-CLEANER
Accommodates:
All Hayward T-CELL-3, Hayward T-CELL-9 and Hayward T-Cell-15 models
Also works with Hayward Swimpure T-Cell-15-SWP Turbo Cells and SuperPro by Hayward T-CELL-15
Simplifies salt cell cleaning!
Reccomended tips to Clean the Aqua Rite Cell:
Turn off power to the Aqua Rite before removing the electrolytic cell. Once removed, look inside the cell and inspect for scale formation (light colored crusty or flaky deposits) on the plates and for any debris which has passed through the filter and caught on the plates. If no deposits are visible, reinstall. If deposits are seen, use a mild acid Wash.  If possible use the Hayward or TC Cell Cleaner adapter.
Place the Turbo Cell in a plastic container, adding a 4:1 solution of water to muriatic acid (one gallon of water to one quart of muriatic acid). ALWAYS ADD ACID TO WATER - NEVER ADD WATER TO ACID. Be sure to wear rubber gloves and appropriate eye protection. The level of the solution in the container should just reach the top of the cell. It may be helpful to coil the wiring before immersing the cell. The cell should soak for a few minutes and then rinse with a high pressure garden hose. If any deposits are still visible, repeat soaking and rinsing. Replace cell and inspect again periodically.
Tips for maintaining the Hayward Aqua Rite System.

If this is not successful, use a plastic tool (do not use metal as this could damage the cell). Note that a buildup on the cell indicates that there is an unusually high calcium level in the pool (incorrect pH level is most likely the cause). The simplest way to avoid this is to bring the pool chemistry to the recommended levels as specified.
To maintain maximum performance, it is recommended that you open and visually inspect the cell every 3 months. The Aqua Rite® will remind you to do this by flashing the "Inspect Cell" LED after approximately 500 hours of operation. After you inspect the cell (and clean, if necessary) press the small "diagnostic" button next to the display for 3 seconds to stop the flashing "Inspect Cell" LED.

The Hayward Aqua Rite electrolytic cell has a self cleaning feature incorporated into the electronic control’s logic. In most cases this self cleaning action will keep the cell working at optimum efficiency. In areas where water is hard (high mineral content) and in pools where the water chemistry has been allowed to get "out of balance", the cell may require periodic cleaning. The "Inspect Cell" LED will indicate if cell efficiency is decreased and servicing is necessary. If the "Inspect Cell" LED remains on after a thorough cleaning, the cell may be worn and require replacement.